Nerf N-Strike Longstrike CS-6 Mod

Name: Longstrike CS-6

Mods: Detachable Stock, Stock Attachment, Grey and Black Paint Job, Air Restricter Removed.

How To: Ok, first thing first- opening it. The best way to do this is to mod it before you put the cocking mechanism through the gun, but it your like me then you didn’t and are now stuck with the thing in there. So to get it out is almost impossible to do with out braking it. What your going to do is take a flat head screw-driver and pry it open. After you do this open one end up and glue any thing that broke.

Now that its open take out the orange clips that are next to the stock, that will let you take the stock out when ever you want to.

The next part takes a Recon or something with a stock attachment and the Detachable Stock mod. Take the stock attachment piece off the gun and start carving out a small channel just above the other stock (this is the place where you’re going to put the bottom of the stock attachment).  Now you’re going to want to grab a spacer of some kind. I used a 1/2 cm piece of modeling wood. Glue this right below the rear sight. Now glue the stock attachment with the bottom in the groove you carved. Let it set for three hour if you used crazy glue and this mods done.

Painting this gun was similar to painting the Recon (Because you have subscribed and watched the video right?!??!) except with this one I followed the line and groove of the gun.

http://nerfgunreviews.com/ar-mod/

Comment: I never let anyone use this gun because I but a lot of work into it and it not the most durable.

(My Longstrike with Raider stock)

MadParadox

 

 

One thought on “Nerf N-Strike Longstrike CS-6 Mod”

Leave a Reply

Your email address will not be published. Required fields are marked *